11
4
2. Unlock cover caps (11) on both sides with key (4) and fold them up.
5
12
3. Loosen screws (12) with tool (5) a quarter of a turn.
Note
Loosening screws (12) allows you to precisely adjust the basic carrier
bars to the width of the vehicle roof. This adjustment only needs to be
carried out at the first fitting.
1
6
4. On both sides of basic carrier bar (1), pull red lever (13) upwards.
Fold quick-tightening device (14) down and then turn it to the left.
5. Place basic carrier bar (1) as shown in front left installation
location (6) onto the vehicle roof so that feet (15) are in the fastening
points (16).
4
M+P-03F-8610
5
M+P-03F-8611
13
14
15
16
M+P-03F-8612
1
11
12
6. On both sides of basic carrier bar (1) press quick-tightening
device (14) down, keep it held down and turn it to the left. Fold
quick-tightening device (14) upwards as fas as it will go and press
down red lever (13).
7. Tighten screws (12) with tool (5).
8. Fold down cover caps (11) on both sides and lock them with key (4).
9. Install rear basic carrier bar (2) in the same way.
G
WARNING
Before each installation, each trip and also during long journeys,
check all screws of the basic rack to ensure that they are seated firmly
and retighten if necessary. Repeat these checks at regular intervals,
regardless of road surface conditions and at the latest after
1,550 miles (2,500 km) of continuous use.
Do not use any lubricants on the screws or the basic carrier. There is
otherwise a risk that the screws loosen, and the basic rack may come
loose from your vehicle together with the load, thus injuring yourself
and other persons and/or causing material damage, including to your
vehicle.
Fitting roof attachments to the basic carrier bars
3
1. Unlock cover caps (11) on both sides with key (4) and fold them up.
2. Pull out cover strip (3), if fitted.
Important
Do not place loads on the cover caps when they are folded up. This may
damage the covers or cause them to break.
3. Push the attachment bracket into slot (17).
Further information can be found in the installation instructions of
the respective equipment to be fitted to the basic carrier bars.
- 7 -
14
17
4
13
M+P-03F-8613
Kg
11
M+P-03F-8614