Publicidad
Idiomas disponibles
Idiomas disponibles
Regulating the water softener with electronic programmer
The water softener can treat water with a hardness level of up to 60°Fh (French grading) or 33°Dh (German grading) through 5 settings.
The settings are listed in the panel below:
Level
2
4
IMPORTANT
The dishwasher must ALWAYS be off before start of this procedure.
1. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF"
button (a brief audible signal will sound).
2. Keep the "PROGRAMME SELECTION" button pressed for at least 5 seconds, UNTIL an audible signal sounds. Some "PRO-
GRAMME SELECTION" indicator lights will come on to indicate the current water softener setting level.
3. Press the same button again to select the required water softener level: each time the button is pressed, one indicator light will come
on (the water softener level is indicated by the number of lights on). For level 5, 4 lights will flash, for level 0 all lights will be off.
4. Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting.
WARNING!
If any problem occurs, turn thedishwasher off by pressing the "ON/OFF" button and start the procedure again from
the beginning (STEP 1).
LEDs
Information for the test laboratories General programme comparison
Ref. EN 60436 standards:
1) Normal load
2) Shine setting: "4"
3) Amount of detergent: 4 gr. for pre-wash, 10 gr. for whash.
Programme
Universal
Hygiene+
Eco
Rapid 32'
* Values are measured in a laboratory according to European Standard EN 60436 (consumption may
vary according to conditions of usage).
Water hardness
°fH (French)
PROGRAMME SELECTION BUTTON
WASHING PROGRAMME
CONSUMPTION (main programmes)*
Power consumption of the off-mode and of the left-on mode: 0,5 W / 1 W
USE
Water hardness
Use of regenerating
°dH (German)
4
Energy (kWh)
1,25
0.93
0.61
0,60
16 GB
Water softener
salt
setting
no
yes
yes
yes
yes
Water (L)
15
12
8
8
Publicidad
