LaserLiner EvolutionCross-Laser 8 Manual De Instrucciones página 17

Adjust vertical slope, to a max. of 2,5° (Z axis)
6
Slope function > 2,5°
7
Steeper slopes can be set using the angle plate, which is available as an
optional extra (product ref. 080.75). To this end you need to use a crank
tripod, such as the 300 cm professional crank tripod, product ref. 080.34.
Refer to the illustrations below.
TIP 1: Set the angle plate to the zero position and allow the device to align
itself automatically. Then press the auto/man button to switch the automatic
sensor off. Finally, incline the device to the angle you require.
TIP 2: Switch the required laser lines on before you activate the slope
function.
2x
Very rapid blinking:
Z axis adjustment up to a max. of 2.5°
2x
One-second rate blinking:
Z axis adjustment up to a max. of 2.5°
EvolutionCross-Laser 8
3 sec
(1 sec)
3 sec
17
GB