Control Panel; Setting Internal Temperature Of Your Product - Ugur UCF 160 L Guia Del Usuario

D- USING YOUR DEEP FREEZER

Control Panel

Green warning light will be on as long as your product runs.
Yellow light will be on when you press fast freezing button or set the thermostat to "S" ("7" depending on the model).
Red warning light will be on when the door of the freezer remains open for a long time or when you load fresh food.
The light will go off after closing the door or food starts freezing.
NOTE
Control panel on your product is not available for every model and it may vary in some models.
Place of the indicator lights and buttons on your product may be different than the ones shown herein. Thus
be careful to the colours stated in the control panel section.
Setting the Internal Temperature of your Product
You can set internal temperature of your product through the thermostat on the control panel:
You can set the thermostat by using a coin etc. that can enter the opening on the button. (Picture 23)
There are min-max and numbers between them on the thermostat button.
EN
Operating ratio of your product will increase as you shift the button toward the position "MAX" and thus
you will gain more cooling.
Operating ratio of your product will decrease as you shift the button toward the position "MIN" and thus
you will gain less cooling.
Factory set thermostat value of your product is position 4. This position is the most efficient position of
the freezer in terms of cooling and energy consumption.
2
1
S
Internal temperature of your product can be set between -18°C and -25°C.
3
4
5
PICTURE 23
3
2
4
1
S
48