Attaching Grass Deflector; Shaft Assembly - GreenWorks 21227 Manual De Utilización

EN
FR DE ES

ATTACHING GRASS DEFLECTOR

See Figure 2.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
■ Remove supplied screws from the motor housing.
■ Fit the plant protector into the slots around the base of
the motor housing.
■ Fit the grass deflector into the slots on trimmer head.
■ Turn counterclockwise to lock grass deflector into
place.
■ Line up the screw holes in the grass deflector with the
holes in the motor housing head.
■ Install supplied screws and tighten by turning
clockwise with a phillips screwdriver.
OPERATION
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
Always wear eye protection. Failure to do so could
result in objects being thrown into your eyes resulting
in possible serious injury.
IT PT NL SV DA NO
WARNING
WARNING
WARNING
FI HU CS RU RO PL
English
FI HU C
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
NOTE: To avoid serious personal injury, always remove
the battery pack and keep hands clear of the lock-out
button when carrying or transporting the tool.
T O INSTALL BATTERY PACK
See Figure 3.
■ Place the battery pack in the trimmer. Align raised ribs
on battery pack with grooves in the trimmer's battery
port.
■ Make sure the latch on bottom of the battery pack
snaps in place and that battery pack is fully seated
and secure in the trimmer before beginning operation.
TO REMOVE BATTERY PACK
See Figure 3.
■ Release the variable speed control trigger to stop the
trimmer.
■ Press and hold the battery latch button at the bottom
of the battery pack.
■ Remove battery pack from the trimmer.

SHAFT ASSEMBLY

See Figure 4.
The shaft's length cannot be adjusted.
■ Insert the lower shaft into the shaft coupler on the
upper shaft.
■ Tighten the coupler by turning clockwise. Make
sure the upper and lower part of shafts are securely
tightened before reinstalling the battery pack.
STARTING/STOPPING THE TRIMMER
See Figure 5.
■ To start he trimmer, grip the front handle with one
hand while holding the rear handle with your other
hand making sure to depress the lock-out trigger while
squeezing the variable speed trigger.
■ To stop the trimmer, just release the variable speed
control trigger.
15
SL HR ET LT LV
WARNING
SK BG