Kit Preparation
1. Remove (4) Phillips screws securing the climate control to the factory
radio/climate-control trim panel.
2. Attach the climate control to the radio trim panel using the factory hardware. (Figure A)
3. Attach (6) panel clips to the radio trim panel. (Figure B)
Continue to kit assembly
(Figure A)
(Figure B)
99-7336S
ISO radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket
radio.
2. Attach the radio brackets to the
radio using screws supplied with
the radio. (Figure A)
3. Secure the completed assembly
to the radio housing using (4) #8
x 3/8" Phillips screws supplied
(Figure B).
4. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and
climate control. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Reconnect
the negative battery terminal and
test the radio for proper operation.
5. Reassemble the dash in reverse
order of disassembly using the
99-7336S radio trim panel.
3
Kit Assembly
(Figure A)
(Figure B)