DeWalt DCS310 Traducido De Las Instrucciones Originales página 42

EN GLI SH
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 3 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
2
is 1 mm ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Installing and Removing the Battery
Pack (fi g. 5)
WARNING: To reduce the risk of injury,
never depress the battery release button
without removing the battery pack.
Depressing the battery release button
without removing the battery pack can
result in the battery pack falling out
unexpectedly.
NOTE: Make sure your battery pack (j) is fully
charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the
handle.
2. Slide it firmly into place until you hear the lock
snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (k) and firmly pull the
battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Variable Speed Trigger Switch (fi g. 1)
To turn the tool on, squeeze the variable speed
trigger switch (a). To turn the tool off, release the
variable speed trigger switch.
40
The trigger switch enables you to start the
application at a slow speed. The further you depress
the trigger, the faster the tool will operate.
LOCK-OFF BUTTON
Your saw is equipped with a lock-off button (b).
To lock the trigger switch (a), press the lock-off
button as shown in figure 3. When the lock-off
button is depressed to the lock icon, the tool is
locked. Always lock the trigger switch when carrying
or storing the tool to eliminate unintentional starting.
OPERATION
Instructions for Use
WALT battery
E
Proper Hand Position (fi g. 1, 4)
Proper hand position requires one hand on the
hand grip (i), with the other hand on the main handle
(h). Hand orientation is dependent upon user's
preference.
Pivot Release Slider (fi g. 3, 6, 7)
WARNING: This tool has no provision
to lock the switch in the on position and
should never be locked on by any other
means.
NOTICE: Use of very slow speed is
recommended only for beginning a cut.
Prolonged use at very slow speed may
damage your saw.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, place
the lock-off button in the lock-
off position or turn tool off and
disconnect battery pack before
making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury.
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
WARNING: To avoid tool being turned
on accidentally, make sure the lock-off
button (b) is engaged.