Dash Disassembly; Kit Preparation - Metra 99-3010S Manual Del Usuario

Ocultar thumbs Ver también para 99-3010S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dash Disassembly

6. For automatic models, remove one
T20 Torx screw from the front of the
shifter, and then remove the knob
and shifter surround panel. (Figure F)
7. Remove (4) Phillips screws now
exposed, and then lift up on the
rear of the center console. Slide
toward the back of the vehicle
then unclip and remove the entire
center console. (Figure G)
8. Remove (2) 7mm screws securing
the climate control/radio trim panel
and remove. (Figure H)
9. Remove (4) 7mm screws securing
the radio chassis, and then remove.
(Figure I)
Continue to kit preparation
(Figure E)
(Figure F)
(Figure G)
(Figure H)
99-3010S
1. Cut and remove the sub dash
radio support to make room for the
interface and harnesses. (Figure A)
2. Remove panel clips from factory
radio and attach to the top of the
kit housing. (Figure B)
Continue to kit assembly
(Figure I)
3

Kit Preparation

(Figure A)
(Figure B)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido