Suntec Wellness Klimatronic ENERGIC 9.0 + Manual Del Usuario página 21

The cold extract air has to be led out of the room via the air hose. This can be executed e.g. via a tilted
window, a door or wall aperture. Make sure that no cold outside air can enter the room. For effective
heating, we recommend our selection of various accessories which reduce or prevent entry of cold air into
the room.
Set the function to „Heating". The settable temperature range is between 15°C and 25°C target
temperature. You can set this using the temperature control.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control
lamp has flashed for three minutes. Cooling effect may require a further 10 minutes. Further information is
available under the part „Troubleshooting".
HEATING IN OUTDOOR OPERATION
The ENERGIC unit is outside the room to be heated. Outdoor operation is ideal for the transition period in
which outside temperatures do no fall below 7°C.
(If the outside temperature should however fall below 7°C
Connect the air hose and the air outlet grid to the ENERGIC
continuously, we recommend indoor operation).
unit as displayed in the illustration, the air hose connection piece and air outlet grid need to be exchanged.
Set the function to „Heating". The settable temperature range is between 15°C and 25°C target
temperature. You can set this using the temperature control.
The air with high oxygen content heated by the ENERGIC unit is fed into the room via the air hose. This
can be executed e.g. via a tilted window, a door or wall aperture. Make sure that no cold outside air can
enter the room. For effective heating, we recommend our selection of various accessories which reduce or
prevent entry of cold air into the room.
Using the "Comfort Control- S Kit" you can also control the ENERGIC unit from inside using the remote
control.
Note: After switching on, or over, the ventilator operates, but the compressor only starts after the control
lamp has flashed for 3 minutes. Cooling effect may require a further 10 minutes. Further information is
available under the part „Troubleshooting".
DEHUMIDIFICATION
Humidity is extracted from the air, collected in the water tank and discharged via the condensation water
outlet. Only air the room if the humidity of the outside air is below than in the inside room. Set the function
to "Dehumidity".
Caution: In the dehumidify mode, separate setting of the ventilator is not provided, since the
lowest ventilation level is already preset to ensure efficient dehumidification of ambient air.
The rubber plug of the condensation water outlet is removed and a drainage hose attached. To collect the
condensation water easily in a tank, a drainage hose is included in the scope of delivery which you can
connect to the upper condensation water outlet. Allow water to flow out continuously in order to achieve
higher dehumification capacity. In the dehumidify mode, you must not feed the room air outside with the
extract air hose.
21