Data Memory; Viewing The Stored Values; Memory Full; Clear All Values - Microlife aponorm Basis Manual Del Usuario

6. Data Memory

4.
At the end of a measurement, this instrument automatically stores
each result, including date and time.

Viewing the stored values

Press the M-button AT briefly, when the instrument is switched
off. The display first shows «M» AP and then a value, e.g. «M 17».
This means that there are 17 values in the memory. The instrument
then switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to toggle between one
stored value and another.

Memory full

When the memory has stored 200 results, the display shows
When the memory has stored 30 results, the display shows
«Full M» after a measurement. From this point onwards, a
new measured value is stored by overwriting the oldest
value.

Clear all values

If you are sure that you want to permanently remove all stored
values, hold down the M-button (the instrument must have been
switched off beforehand) until «CL» appears and then release the
button. To permanently clear the memory, press the M-button
while «CL» is flashing. Individual values cannot be cleared.
14

7. Replacing the Slot-in Card

5.
You can replace the slot-in card 3 by pulling it out to the side, as
shown in Fig. IV and replacing the paper insert.
It may be helpful to have your doctor note down the medication
dosage or an emergency telephone number on the card. Extra
cards are supplied with the instrument for this purpose.

9. Battery Indicator and Battery change

6.

Batteries almost flat

When the batteries are approximately ¾ used the battery symbol
AO will flash as soon as the instrument is switched on (partly filled
battery displayed). Although the instrument will continue to
measure reliably, you should obtain replacement batteries.
Batteries flat – replacement
When the batteries are flat, the battery symbol AO will flash as
soon as the instrument is switched on (flat battery displayed). You
cannot take any further measurements and must replace the
batteries.
1. Open the battery compartment 7 at the back of the instrument
by pushing inwards at the two arrows and pulling out the
battery compartment cover.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 2.».
The memory retains all values although date and time (and
possibly also set alarm times) must be reset – the year
number therefore flashes automatically after the batteries
are replaced.

Which batteries and which procedure?

Please use 4 new, long-life 1.5V, size AA batteries.
Do not use batteries beyond their date of expiry.
Remove batteries, if the instrument is not going to be used
for a prolonged period.
aponorm ® by