Connecting To Power - Roadstar HIF-1690BT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
3
English

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the
same as that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to
connect this unit to the mains.
1. Turn the VOLUME KNOB (12) to turn the unit ON. When no sound is produ-
ced, the unit will switch OFF automatically after 15 minutes.
2. Press PLAY / PAUSE BUTTON (2) again to resume the playback.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to
other power sources may damage the unit.
Caution: to prevent electric shock disconnect from the mains before remo-
ving cover. No user serviceable parts inside. Refer servicing to qualified service
personnel. Remove the stereo carefully from the box, retaining the packaging for
future use. Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
RADIO OPERATION
ANTENNA
For FM reception there is a built-in pig-tail FM antenna (28) at the rear of the unit.
Extend the antenna and move around to obtain the best reception signal.
Operation
1. Turn VOLUME KNOB (12) to switch the unit on.
2. Select between AM and FM by pressing (36)/(37).
3. Tune to the desired radio station by turning the TUNING KNOB (21).
TURNTABLE OPERATION
VERY IMPORTANT!
To prevent damages from transportation, a transit screw is located at the upper
right side of the turntable platform. Before start playing, use a screwdriver and
turn the transit screw in clockwise direction (screw going down) completely. In ca-
se of transportation, remember to clock again this screw in counter-clockwise di-
rection to prevent damages.
Preparation
1. Open the Record Player Cover.
2. Release the Tonearm Clamp, and remove the stylus protector.
Listening to Records
1. Press PHONO (7).
2. Place a record on the turntable, over the central spindle. Place the EP adapter
over the central spindle when playing 17cm EP records.
3. Set the Speed Selector (24) to 33/78 or 45 rpm according to the record.

Publicidad

Tabla de contenido
loading

Tabla de contenido