Mounting; Electrical Installation - SICK GRL18V Instrucciones De Operación

4
OPERATING AND STATUS INDICATORS
5

Mounting

6

Electrical installation

6
–
+
Figure 1: Operating element: sensitivity setting
Mount the sensor and the reflector using suitable mounting brackets (see the SICK
range of accessories). Align the sensor and reflector with each other.
max. 90 Nm
Note the sensor's maximum permissible tightening torque of 90 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (following tables):
Q / Q = switching outputs
n. c. = not connected
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
8021183.1ABM / 2020-12-21 | SICK
Subject to change without notice