Frico Thermozone AC 300 Manual De Instrucciones página 22

GB
Security
• Ensure that the area around the intake and
exhaust grille is kept free from material
which could prevent the air to flow through
the unit!
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with clothes, or similar materials,
as overheating can result in a fire risk!
Maintenance
NOTE! Disconnect electricity prior to cleaning
or inspection (units with electric heat can be
supplied from more than one connection).
The fan motors and the other components
require no maintenance other than cleaning
when necessary, however at least once year.
Grille, impeller and elements are vacuum
cleaned or dried clean with a damp cloth.
Open the inspection hatch to reach elements
and impellers.
Safety cut-out
(applies to units with electric heat)
If the installation is protected by means of a
safety cut-out, which trips when the appliance
is connected, this may be due to moisture in
the heating element. When an appliance
containing a heater element, has not been
used for a long period and is stored in a
damp environment, moisture can enter the
element. This should not be seen as a fault,
but is simply rectified by connecting the
appliance to the mains supply via a socket
without a safety cut-out, so that the moisture
can be driven out of the element.
The drying time can vary from a few hours
to a few days. As a preventive measure the
Thermozone should occasionally be run for a
short time when it is not being used for an
extended period of time.
The garantee is only valid if the
Thermozone units are used in the manner
intended by the manufacturer and in
accordance with the installation and
maintenance instructions.
22
Thermozone AC 300
Manufacturer
Our products are manufatured in accordance
with applicable international standards and
regulations.
Frico AB
Box 102
SE-433 22 PARTILLE
SVERIGE
The manufacturer hereby declares that the
following products
AC301, AC302, AC308, AC312,
comply with the following EC-directives.
EC Declaration of Conformity
Defined by the EC Low Voltage Directive
73/23/EEC.
The following harmonised standards are in
use:
SS-EN 60 335-1: 1988, A2, A5, A6,
A51- A54, A56
SS-EN 60 335-2-30: 1992, A51, A52
Complete technical documentation is
available.
EC Declaration of Conformity
Defined by the EC Electromagnetic
Compatibility Directive 89/336/EC och
92/31/EC.
The following harmonised standards are in
use:
SS-EN 50 082-1: 1992
SS-EN 60 555-2/3: 1991
Complete technical documentation is
available.
Partille, 19 januari 1998
Mats Careborg
Technical Manager