Ac Current Measurements; Dc Voltage Measurements - Southwire 23030T MaintenancePRO Instrucciones De Uso

Operation cont.

AC Current Measurements

WARNINGS:
Disconnect the test leads and temperature probe from
the meter before making current clamp measurements. Do not measure
current on conductors that are more than 600V above earth ground if in a
CAT IV application or more than 1000V above earth ground if in a CAT lll
application. Observe safety precautions when working on live conductors.
1. Set the rotary function switch to the 600A or 1000A position.
2. If the range is not known, select the higher range first, and then move to the
lower range if necessary.
3. Press the trigger to open the jaw.
Clamp around a single conductor making
sure the jaws are fully closed before
taking a measurement. For best results,
center the conductor inside the jaw.
4. Read the current on the LCD display.
NO
Incorrect
YES
Correct
9
Operation cont.
AC Voltage Measurements
WARNING:
Observe all safety precautions
when working on live voltages.
1. Set the rotary function switch
to the V~ position.
2. Insert the black test lead into the
COM input jack and the red test
lead into the V input jack.
3. Touch the test lead probes to the
circuit under test.
4. Read the voltage on the LCD display.

DC Voltage Measurements

WARNING:
Observe all safety precautions
when working on live voltages.
1. Set the rotary function switch
to the V
position.
2. Insert the black test lead into the
COM input jack and the red test
lead into the V input jack.
3. Touch the test lead probes to the
circuit under test. Touch the red
test lead to the positive side of the
circuit and the black test lead to
the negative side of the circuit.
4. Read the voltage on the LCD display.
V
V
10