Assembly - Klarfit Treppo Manual De Instrucciones

EN

ASSEMBLY

Step 1
Place the base caps (5) on the rear base (4). Place both dampers (9) on the
rear base (4). Fasten the rear base (4) to the lower main frame (1) with the two
screws (8), two curved washers (3), two spring washers (48) and two nuts (2).
Note: Ensure that the rear base transport wheels are facing outwards and
all screws are tightened firmly to prevent vibrations later on.
Fasten the end caps (19) to the pedal tubes (22) with an Allen screw (17) and
a washer (18). Then insert the end caps (16) and attach the pedal tubes to the
support frame (24).
Note: Pay attention to the markings (L) and (R) when mounting the pedal
tubes. The step indicator does not work if the pedal tubes are mounted
upside down.
30