FRIEDLAND SPECTRA 140 Manual De Instrucciones página 6

15M
Fig. 4
Fig. 5
2
MOUNTING
After choosing a suitable location, fit the
unit as follows:
Remove the top cover of the unit by
gently twisting a flat bladed screwdriver
blade in the slot provided, as shown
in Fig. 6.
15M
MOUNTING
3
Place the back plate of the unit in
the desired position and mark the
locations of the mounting holes [Fig. 6].
Next drill the holes to the required
depth and insert the wall plugs.
Cabling can either be from directly
behind the unit through the wall, or
along the surface from below - via the
gaps provided in the housing [Fig. 7].
Pierce the grommets and feed the
recommended cable through them,
ensuring a watertight seal.
Screw the unit to the wall - do not
over-tighten screws.
Connect cables according to one of
the diagrams in Section 3.
Re-assemble the unit.
HOLES
Fig. 6 CUT-OUTS FOR
SURFACE WIRING
Fig. 7