Connecting The Pumps - Varian 212-LC Manual Del Usuario

Connecting the Pumps

•
If the installation does not start automatically, execute
SETUP.EXE from the root directory of the CD.
•
Follow the on-screen instructions until the installation is
complete.
To verify that the 212-LC driver is present, right-click on the right side of
the Workstation toolbar and select Enable/Disable Instrument
Modules.
In the resulting dialog, verify that the 212-LC driver is listed in the
enabled or disabled modules. If the 212 is listed with the disabled
modules, highlight it, click Enable, then click OK.
Refer to Figure 2 for a view of the back of the instrument. The cable
linking the two pumps should already be connected from the Output of
Pump A to the Input of Pump B.
Now connect the 212-LC control cable included with the pumps between
the Input connector of Pump A and an available serial port of the PC in
the range COM1-COM4.
20