Audio-Technica AT-WLA1 Manual Del Usuario página 7

Attaching the product
Attaching the product to the headphones
Attach this product to a pair of headphones. For details
on the recommended headphones, see "Recommended
headphone models" (p. 14).
• Turn this product off, remove the USB charging cable,
and then connect or disconnect the headphones.
Attaching the product
Check the "L" (LEFT) and "R" (RIGHT) parts of the
headphones and of this product's cable, and then
insert the cables into the headphones as shown in
the figure until you hear a click.
Removing the product
Holding the part of this product's cable connected to
the headphones, pull straight in the direction of the
arrow to remove the product.
*1 There is a delicate pin on the headphone side of the connecting
part. Exercise caution when handling this part. If you pull on or
insert this part at an angle, the pin may bend, which may result
in malfunctions.
*2 Do not touch this product's connectors directly. Doing so may
lead to contact failure.
Attaching the ear hooks (included; for headphones that wrap around the ear)
With headphones that wrap around the ear, to obtain a
stable fit, you can attach the product to the ear hooks
after attaching the product to the headphones.
Check the sides of the ear hooks marked "L" (LEFT) and
"R" (RIGHT), and then attach the "L" ear hook to the "L"
side of the product and the "R" ear hook to the "R" side
of the product.
Insert the headphone's bushing and cable into the
groove on the inside of the ear hook.
Headphone side
Pin *1
6
Headphone
Cable side
Holding the base of this product's
cable, insert/remove it straight in the
direction of the arrow.
*2
2
1
L
L: LEFT
R: RIGHT