Descargar Imprimir esta página

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20

General notes

These installation instructions belong to the vehicle. Therefore, you
should always keep them in the vehicle.
In the case of vehicles with a 7-pin plug socket, an adapter (7-pin to
13-pin) is available from your Mercedes-Benz Service Centre.
The rear-mounted bicycle rack covers the licence plate and the lighting
system of the vehicle partially or completely. For this reason, when the
rear-mounted bicycle rack is mounted, a licence plate bearing the official
licence number of the vehicle must be attached and the plug connection
of the lighting system must be plugged in. When the rear-mounted bicycle
rack is fitted correctly to the vehicle, the vehicle's rear foglamps do not
function.
The permissible noseweight of the trailer coupling must be at least
110 lbs (50 kg) and the drawbar ratio of the coupling ball must be at least
6.7 kN (6.2 kN on the A-Class model series 168). These figures are
shown on the type plate of the trailer coupling.
Observe the relevant registration provisions/ legal requirements of the
country in which you are using or intend to use the rear-mounted bicycle
rack on the road.
H
DISPOSAL NOTICE
In order to preserve and protect the environment, to prevent
pollution and in order to improve the recycling of resources,
the European Commission has issued a directive (WEEE
directive 2012/19/EU and WEE regulation) according to
which manufacturers must take back electric and electronic equipment
in order to have them properly disposed of or recycled.
Devices carrying this symbol may not be disposed of together with
unsorted household waste within the European Union: please contact
your local authorities for information on the correct method of disposal.
The materials are recyclable in accordance with their labelling.
Through re-use, recycling of raw materials, or other forms of recycling
of obsolete equipment, you are making an important contribution to
the protection of our environment.
Notes on care
Clean the rear-mounted bicycle rack as you would clean your vehicle. Be
aware of any damage to the painted surfaces and repair them if
necessary.
Do not drive through an automatic car wash with the rear-mounted
bicycle rack mounted.
Folding up the rear-mounted bicycle rack
7
1. Fold up retaining bar (6) and close locks (7).
2. Fold out rails (8) and allow them to engage.
Folding up the rear-mounted bicycle rack
1. Press the „PUSH" button and push the wheel holders on rails (8)
2. Fold in rails (8).
3. Press locks (7) and open them towards the rear.
4. Fold down retaining bar (6).
Positioning the bracket on the retaining bar
Brackets (9 and 10) can be removed to load the rack and can be
reattached to retaining bar (6) in the desired position.
1. Fold up bracket (9 or 10) and unlock it with key (3).
2. Pull latch (11) and pull out tensioning strap (12).
3. Open up lock (13) as far as it will go, swing open fixture (14) and
4. Release collar (15) as shown.
5. Apply collar (15) at the desired position on retaining bar (6) and close it.
6
6. Place bracket (14) in a form locking manner around sleeve (15) and
7
Note
7
Locking the bracket with key (3) also secures locks (13). This acts as
anti-theft protection.
M+P-03F-8040
- 8 -
8
outwards.
11
3
12
9
13
9
remove bracket (9 or 10).
turn lock (13) to „LOCK".
8
M+P-03F-8041
13
14
15
9
6
10
M+P-03F-8191

Publicidad

loading

Este manual también es adecuado para:

A0008901700