Safety; Safety Conditions - Ingeteam Ingecon EMS Home Serie Manual De Instalacion Y Uso

Ingeteam

3. Safety

3.1. Safety conditions

General warnings
All applicable safety-related legislation for electrical work must be complied with. Danger of electric
shock.
Compliance with the safety instructions set out in this manual or in the suggested legislation does
not imply exemption from other specific standards for the installation, place, country or other
circumstances that affect the inverter.
The housing must not be opened by the user. Only the installer (qualified personnel) may access the
inside of the unit.
Ingeteam accepts no liability for any consequences arising from a failure to follow this guideline.
Ingeteam accepts no liability for any damages caused by improper use of the equipment. Any work
carried out on any equipment which implies a modification of the original electrical arrangements
must be proposed in advance to Ingeteam. These must be studied and approved by Ingeteam.
The entire manual must be read and understood in full prior to operating the unit.
Following is a list of the basic obligatory safety standards for each country:
• RD 614/2001 in Spain.
• CEI 11-27 in Italy.
• DIN VDE 0105-100 and DIN VDE 1000-10 in Germany.
• UTE C15-400 in France.
The space for the installation of the battery bank must be properly ventilated.
The battery bank must be installed so that any accidental short-circuits are avoidable.
Potential hazards for people
Bear in mind the following warnings concerning personal safety.
HAZARD: electric shock.
The equipment may remain charged after disconnecting the renewable power supply and mains
power.
HAZARD: high temperature.
The flow of outlet air can reach high temperatures which can cause injury to anybody exposed to it.
52 - English
Safety
ABH2000IKE02_ - User manual