Stopper And Strips Installation - OVE GRANADA 60 Manual Del Usuario

STOPPER AND STRIPS INSTALLATION

1. Place the stopper (LL) on the track (F) on the fixed panel side. Find the correct position by closing the door
on it. It should prevent the door from hitting the track, but should not hinder the opening and closing motion of
the door.
2-3. Mark the position of the stopper (LL) and drill the holes with ø3mm (1/8in) drill bit.
4. Install the stopper (LL) on the track (F) using screws (DD) and insert the block (KK).
5. Place the covers (Q) on the tracks (F). Use a rubber mallet to make it easier.
6. Put the cap (HH) on the top and bottom tracks (G & N).
7. Place the gasket (T) between the fixed panel (D) and the track (F). Use a wood stick for help as it will fit
tightly.
1
LL
B
view from inside
3
ø3 mm
1/8 in
Helpful Hint
Use rubber mallet to push
the covers from top to
bottom.
5
Q
view from inside
F
6
HH
G
HH
N
view from outside
18
2
4
DD
KK
Helpful Hint
Use the corner of a wood stick
to push the gasket inside, as the
opening is tight.
7
T