Bassinet Assembly; Bassinet Operation - UPPAbaby VISTA Manual Del Usuario

BASSINET ASSEMBLY
SET-UP THE BASSINET
STEP 1: Remove mattress.
STEP 3: Pull both steel braces firmly into their
respective sockets. Make sure that both braces
are properly locked in place.
STEP 5: Pull bassinet canopy upright and fasten
canopy to Velcro strips at top of liner.
UPPAbaby VISTA Instruction Manual
STEP 2: Fold back liner.
STEP 4: Replace bassinet liner and mattress.
STEP 3: To remove, (arrow 1) simultaneously push down
both release buttons and (arrow 2) lift the seat from
the frame.
STEP 6: ATTACH BASSINET COVER
1: Place the closed end of the cover over the bottom
of the bassinet, and pull the cover toward the top of
the bassinet.
2: Fasten the ends of the bassinet cover to
the outside of the canopy with the Velcro strips.
8
BASSINET OPERATION
ATTACH BASSINET
TO STROLLER
STEP 1: Insert the posts on the sides of bassinet
into the slots on the frame. Push until you hear it
"click" on both sides.
STEP 2: Check carefully that the bassinet is properly
attached to the frame by pulling up on the bassinet
carry handle.
NOTE: Bassinet attaches only in the rear-facing
direction so infant is facing the user.
VENTILATED CANOPY
STEP 1: Unzip the bottom zipper on the canopy
hood exterior.
STEP 2: Lift and line up seam half-way until
magnets connect.
TO REMOVE BASSINET
STEP 1: Lift rear lever firmly and completely (90˚).
STEP 2: Lift bassinet off of frame using
carrying handle.
NOTE: Bassinet must be removed
from stroller to fold.
FOR ADDITIONAL
VENTILATION
Undo Velcro flap found on bottom exterior of
bassinet and adhere to lower Velcro strip.
9
ENGLISH