Troubleshooting Procedures - Kohler Sonata K-1683 Manual Del Usuario

Remove the Jets
Insert the tool hook as shown and pull
the jet out of the housing. The jet
should be facing up when this is done.

10. Troubleshooting Procedures

Remove the Factory Installed Jet
NOTE: A special tool is provided with the replacement jet that will allow you to remove the jet from the whirlpool. The tool is
also packed with each trim kit.
- Position the jet ball nozzle so it is pointing upward.
- Insert the removal tool, hooked end up, into the opening of the jet and hook the inside top of the nozzle.
- Grasp the tool firmly and place your thumb against the bath wall. Pull on the jet assembly until it pulls from the hole. Be
careful not to lose the O-ring.
NOTE: The nozzle must remain pointed up or the tool will slip off.
Re-install the Jets
NOTE: The jet O-ring must be correctly positioned, must be lubricated, and must be in good condition to permit easy rotation
and proper operation of the jet.
- Install the O-ring onto the first shoulder of the jet. Lubricate the O-ring with silicone lubricant to prevent noisy operation of
the jet.
- Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into position. Do not force the jet.
NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.
B
1022475-2-
Re-install the Jets
Housing
Inspect and
lubricate the
O- -ring
Insert the jet into the
housing, and lightly push
and rotate until it snaps
in position
10
Slide the O- -ring onto the
first shoulder of the jet
Kohler Co.