Krups Espresso Novo 2300 Plus Manual De Instrucciones página 22

Turn the selector to the steam pre-heating
•
position (19).
Turn the tap to the cleaning position
•
(33).
Immerse the flexible tube into a glass of
•
water. (The minimum quantity necessary is
100 ml).
Place a container below the outlet nozzle.
•
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
Then turn the selector to the steam setting
•
(22).
When all the water has run through the
•
autocappuccino accessory turn the selector
to the O position.
After use, remove the flexible tube from the
•
container.
Once this operation is completed, clean the
•
outlet nozzle with a damp cloth.
We recommend that you regularly dismantle
the autocappuccino accessory and clean it
with water, a little non-abrasive washing-up
liquid and a small brush. Rinse and dry before
reassembling it (34).
Be careful to mount the flexible tube the
right way: engage the straight cut end into
the autocappuccino accessory.
. Percolation head gasket
From time to time this gasket must be cleaned :
Put the filter in the filter holder.
•
• Place a jug or container under the filter
holder.
Switch on the appliance.
•
Turn the selector to the setting
•
When the hot water starts to filter through,
•
turn the filter holder slowly from left to right
so that the water filters through between
the gasket and the filter.
Descaling
Descaling of your espresso should be done
•
fairly frequently with citric or tartaric acid.
22
However, we would advise you to use the
Krups descaling accessory, reference 054,
which is available from Krups after-sales ser-
vice centres. This accessory includes, apart
from two descaling doses, a testing strip for
water hardness to assess the frequency of
descaling of your appliance in normal use.
Descaling depends on the hardness of the
water, but also on the use cycle. The frequently
of descaling indicated by the 054 accessory is
thus given by way of indication only.
- Then follow the following method:
Unscrew the grid from the head of the
•
appliance and clean it.
Dissolve 2 dessertspoons of the descaling
•
product or a sachet of KRUPS descaling
accessory, reference 054, in half a litre of
lukewarm water and pour the whole lot into
the empty water tank.
Place a container under the brewing head.
•
Run through about 1/3 of the liquid
immediately, setting the selector to the
position (9).
Stop the appliance, leaving the
•
(9) engaged and wait for 10 - 15 minutes to
allow the descaler to take effect.
Next, start the machine again and allow the
•
rest of the liquid to run through.
Then rinse with two water tanks of fresh
•
water and replace the grid on the head of the
appliance (see paragraph on maintenance).
Problems, probable causes and
how to correct them
Problems Probable causes Corrective actions
Espresso not hot The accessories
enough (cups, filter and
filter holder
are cold).
Coffee leaks The filter holder
around the filter has not been as-
holder sembled correctly
There are coffee
grounds on the
edge of the filter
position
Preheat the
accessories (cups,
filter, filter holder)
See paragraph
«Preparing an
espresso».
See paragraph
«Preparing an
espresso».
Clean around the
filter and the
gasket.