Legal Notices; Product Name; Emc Requirements Of Ec Directive; Laser Safety - Canon imageRUNNER ADVANCE C3330i Guía De Asistencia

Legal Notices

Product Name

Safety regulations require the product's name to be
registered. In some regions where this product is sold,
the following name(s) in parenthesis may be registered
instead.
imageRUNNER ADVANCE C3330i/C3325i/C3320/
)
C3320i (F167600)

EMC requirements of EC Directive

This equipment conforms with the essential EMC
requirements of EC Directive. We declare that this
product conforms with the EMC requirements of EC
Directive at nominal mains input 230 V, 50 Hz although
the rated input of the product is 220 to 240 V, 50/60 Hz.
Use of shielded cable is necessary to comply with the
technical EMC requirements of EC Directive.

Laser Safety

This Product is certified as a Class 1 laser product under
IEC60825-1:2007 and EN60825-1:2007. This means that
the product does not produce hazardous laser radiation.
Since radiation emitted inside the product is completely
confined within protective housings and external covers,
the laser beam cannot escape from the machine during
any phase of user operation.
Do not remove protective housings or external covers,
except as directed by the equipment's manual.

Additional Information

When servicing or adjusting the optical system of
the product, be careful not to place screwdrivers or
other shiny objects in the path of the laser beam.
Also, accessories such as watches and rings should be
removed before working on the product.
The reflected beam, even though visible or invisible, can
permanently damage your eyes.
The label shown below is attached to the inside of the
front cover.
This Product has been classified under IEC60825-1:2007
and EN60825-1:2007, which conform to the following
classes;
CLASS 1 LASER PRODUCT
LASER KLASSE 1
APPAREIL Á LASER DE CLASSE 1
APPARECCHIO LASER DI CLASSE 1
PRODUCTO LÁSER DE CLASE 1
APARELHO A LASER DE CLASSE 1
LUOKAN 1 LASER-TUOTE
LASERPRODUKT KLASS 1
CAUTION
Use of controls, adjustments, or performance of
procedures other than those specified in the manuals for
this machine may result in hazardous radiation exposure.

Legal Notices

93