Publicidad
Idiomas disponibles
Idiomas disponibles
• Do not remove or deface warning labels. If labels are removed,
E
the user or others may inadvertently expose themselves to
radiation.
• Position the laser securely on a level surface. If the laser falls,
damage to the laser or serious injury could result.
Personal Safety
• Stay alert, watch what you are doing, and use common sense
when operating a laser product. Do not use the tool while
tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating laser products may result
in serious personal injury.
• Use appropriate personal protective equipment, including eye
protection when working in a construction environment.
Tool Use and Care
• Do not use the tool if the switch does not turn it on or off. Any
tool that cannot be controlled with the switch is dangerous and
must be repaired.
• Store idle laser products out of the reach of children and do
not allow persons unfamiliar with the laser product or these
instructions to operate the laser product. Laser products are
dangerous in the hands of untrained users.
• Use only accessories that are recommended by the
manufacturer for your model. Accessories that may be suitable
for one tool, may become hazardous when used with another tool.
Batteries and Power
This D
WALT rotary laser will accept all D
e
battery packs, but is built to best resist damage during a fall when
used with the following batteries: All 1.5Ah and 2Ah D
lithium ion battery packs.
Charging the Battery Pack
The battery pack is not fully charged out of the carton. You need to
use a D
WALT 20 volt charger to charge the battery pack before you
e
can use the rotary laser.
• Be sure to read all safety instructions before using your charger.
14
NOTE: When ordering replacement battery packs, be sure to include
the catalog number and voltage.
Installing the D
WALT 20 volt lithium ion
e
Removing the Battery Pack
WALT 20 volt
e
WARNING:
DO NOT attempt to charge the battery pack with any
chargers other than the ones listed in this manual. The
charger and battery pack are specifically designed to work
together.
WARNING:
Carefully follow all instructions and warnings on the battery
label and package and accompanying Battery Safety
Manual.
Slide the battery pack into the charger as described in the
1.
Battery Safety Manual.
Wait until the battery pack is fully charged.
2.
Slide the battery pack out of the charger.
3.
WALT 20V Battery Pack
e
Position the fully-charged D
1.
release button (Figure
D 1
right.
Press and hold down the release button (Figure
2.
battery pack.
Slide the battery pack all the way into the track on the side of
3.
the laser (Figure
).
D 2
Release the button on the battery pack.
4.
Press and hold the release button on the battery pack (Figure
1.
).
1
Slide the battery pack out of the track on the laser.
2.
Release the button on the battery pack.
3.
To recharge the battery pack, insert it into the charger, as
4.
described in the Battery Safety Manual.
WALT 20V battery pack so the
E
) is facing away from you and to the
) on the
D 1
D
Publicidad
