Publicidad
Idiomas disponibles
Idiomas disponibles
Select ACTIONS.
10.
E
• If you are using more than one rotary laser and need to check
which laser is paired with the application, press the Identify
button at the bottom of the screen. On the paired laser, the
blue LED next to
• If you need to, you can enable, disable, or unpair the laser.
Select Rotary Control to change the setting for the rotary laser.
11.
• When
is selected, choose the rotation speed (150, 300,
600, or 1200).
• Select
and choose the rotation angle (0, 15, 45, 90, or
15˚/45˚/90˚
360) and the rotation direction (
• Select
and choose the Slope Setting, Axis Setting (X or
Y), Slope Configuration (% or degree), # degree or %.
Use your cell phone to control the laser.
12.
When you are ready, turn the laser off from the Diagnostic screen.
13.
Unpairing the Detector from the Application
To unpair the Detector connection to the D
application and return to pairing the application with the laser unit, follow
these steps.
On the D
WALT
Tool Connect™ application, unpair the detector
1.
®
E
connection on the Diagnostics screen.
Turn off the detector.
2.
On the laser keypad, press
3.
connection with the detector. Once the detector is unpaired from the
laser, the laser will automatically switch back to being paired with the
D
WALT
Tool Connect™ application.
®
E
You can then make sure that the laser unit is paired with the
4
application. On the ACTIONS screen, select the Identify button at
the bottom of the screen. The blue LED will flash on the paired laser
unit.
Then, if you want to unpair the laser unit from the D
5
Connect™ application, you can unpair it from the Actions screen.
24
will blink.
or
).
WALT
Tool Connect™
®
E
(Figure
) to turn off the
A 6
WALT
E
Accessories
Recommended accessories for use with your tool are available for
purchase at your factory-owned local service center.
WARNING:
Since accessories other than those offered by D
not been tested with this laser, use of such accessories with
this laser could be hazardous. To reduce the risk of injury,
only use D
use with this rotary laser.
If you need assistance in locating any accessory, please visit our
website www.D
WALT.com
e
Mounting Bracket
Some laser kits include a mounting bracket, which can be used for
attaching the tool to a track or to a ceiling grid to aid in acoustical
ceiling installation. Follow the directions below for using the mounting
bracket.
CAUTION:
Before attaching the laser level to wall track or ceiling
angle, be sure that the track or angle is properly
secured.
Place the laser on the mounting base (Figure
1.
5/8–11 screw hole on the tripod adapter (Figure
to the bottom of the laser with the hole (Figure
mounting base.
Turn the mounting knob (Figure
2.
With the bracket's measuring scale (Figure
3.
loosen the clamp locking knob (Figure
jaws.
Position the clamp jaws around the wall track or ceiling angle
4.
and tighten the clamp locking knob (Figure
clamp jaws onto the track. Be sure that the clamp locking knob
is securely tightened before proceeding.
Tool
®
WALT
accessories that are recommended for
®
E
) to secure the laser.
Q 3
Q 7
) to open the clamp
Q 8
Q 8
WALT have
E
) aligning the
Q 5
), attached
G 1
) in the
Q 6
) facing you,
) to close the
Publicidad
