Publicidad
Idiomas disponibles
Idiomas disponibles
Level Calibration Check (Y-axis)
E
Set up a tripod between two walls that are at least 50 feet apart. The
1.
exact location of the tripod is not critical.
Make sure that the top of the tripod is roughly level.
2.
• The laser will self-level only if the top of the tripod is within ±
5˚ of level.
• If the laser is set up too far out of level, it will beep when it
reaches the limit of its leveling range. No damage will be done
to the laser, but it will not operate in an "out of level" condition.
Attach a tripod adapter (Figure
3.
adapter may be assembled to the bottom for level mode (Figure
) or to the side for plumb (vertical) mode (Figure
G 2
Place the laser with the attached adapter on the tripod and
4.
screw the threaded knob on the tripod into the female thread on
the tripod adapter.
Position the laser unit on the tripod so that the laser's Y-axis
5.
points directly toward one of the walls (Figure
Turn the laser unit on and allow it to self-level.
6.
Where the beam appears on the left wall, mark point A, and where
7.
the beam appears on the right wall mark point B.
Turn the laser unit 180º so that the Y-axis points directly toward
8.
the opposite wall (Figure
Allow the laser unit to self-level.
9.
Where the beam appears on the left wall, mark point AA, and
10.
where the beam appears on the right wall mark point BB.
Calculate the Total Error using the following equation:
11.
Total Error = (AA-A) - (BB-B)
18
) to the laser unit. The
G 1
I
).
N 1
).
N 2
If your Total Error measurement is greater than the Allowable
12.
Error for the corresponding Distance Between Walls in the
following table, the laser must be serviced at an authorized
service center.
L (Distance Between Walls)
40' (15m)
50' (20m)
70' (25m)
100' (30m)
Plumb Error Check
Perform this check using a wall that is no shorter than the tallest wall
).
3
for which this rotary laser will be used (Figure
Using a standard plumb bob as a reference, mark the top and
1.
bottom of a wall. (Be sure to mark the wall and not the floor or
ceiling).
Position the rotary laser securely on the floor approximately 3"
2.
(1m) from the wall.
Turn the laser on and point the laser dot at the mark on the
3.
bottom of the wall.
Using the
or
4.
), rotate the dot upwards.
B 7
If the center of the dot scans over the mark on the top of the
5.
wall, the laser is properly calibrated.
Using the Laser
Using the Laser on a Tripod
Position a tripod securely and set it to the desired height. Make
1.
sure that the tripod has a 5/8"-11 threaded screw to ensure
secure mounting of the laser unit.
Make sure that the top of the tripod is roughly level.
2.
• The laser will self-level only if the top of the tripod is within ±
5˚ of level.
• If the laser is set up too far out of level, it will beep when it
reaches the limit of its leveling range. No damage will be done
to the laser, but it will not operate in an "out of level" condition.
Allowable Error
3/64" (1.5mm)
1/16" (2mm)
3/32" (2.5mm)
1/8" (3mm)
).
O
arrow on the Remote Control (Figure
or
B 6
Publicidad
