Prebena PKT-8-PR100 Traducción Del Manual Del Usuario Original página 132

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 162
Operation
Triggering the fastener driving tool repeatedly
▶ Choose triggering process "Contact triggering with automatic
reset" by pressing the "TTT" button (trigger multiple times) on the
control panel. The blue LED flashes.
▶ Press and hold the triggering mechanism.
▶ Place the triggering safety device of the fastener driving tool on
the material and press the fastener driving tool briefly against the
material.
A nail is driven into the material.
▶ Within 5 seconds, place the tool tip on the next desired position
and briefly press the fastener driving tool.
Another nail is driven into the material.
You can repeat this process as long as you hold the triggering
mechanism depressed and there are nails in the magazine.
▶ To end nail driving, release the triggering mechanism.
▶ Lift the fastener driving tool up off the material.
52
WARNING
Accidental triggering may result in severe or fatal
injuries.
▶ Do not point the fastener driving tool at
yourself, other people or animals.
▶ Do not leave your finger on the trigger when
the device is picked up, moved between work
areas and positions, or when walking, as
leaving your finger on the trigger can lead to
unintended operation.
▶ In the case of devices with switchable
triggering, always check that the device is set
to the correct mode before use.
▶ Do not use this tool in contact actuation for
applications such as closing boxes or crates
and fitting transportation safety systems on
trailers and lorries.
▶ Be careful when changing from one driving
location to another.

Publicidad

Tabla de contenido
loading

Tabla de contenido