Power Supply Unit; Fcc Statement; Warranty - Beurer BM 50 Manual De Instrucciones

13. Power Supply Unit

Input
Output
Protection
Enclosures and
Protective Covers

14. FCC Statement

Changes or modifications to the product not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTICE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

15. Warranty

Limited Lifetime Warranty For Original Purchaser
Your Beurer Blood Pressure Monitor, Model BM 50, is warranted to be free from defects in materials and
workmanship for the life of the product under normal conditions of intended use and service. This warranty
extends only to the original retail purchaser and does not extend to retailers or subsequent owners.
We will, at our option, repair or replace the Beurer Blood Pressure Monitor, Model BM 50, without additional
charge, for any part or parts covered by these written warranties. No refunds will be given. Repair or
replacement is our only responsibility and your only remedy under this written warranty. If replacement parts
for defective materials are not available, Beurer reserves the right to make product substitutions in lieu of
repair or replacement.
100 – 240 V, 50 – 60 Hz
6 V DC, 600 mA, only in connection with this Beurer blood pressure monitor.
This device is double insulated and protected against short circuit and
overload by a primary fuse.
Make sure to take the batteries out of the compartment before using the
mains part.
Polarity of the the DC voltage connection
Double insulated / equipment class 2
Equipment enclosed to protect against contact with live parts, and with parts
which can become live (finger, pin, hook test).
The operator shall not contact the patient and the output plug of AC mains
part simultaneously.
14