Measuring Blood Pressure - Beurer BM 50 Manual De Instrucciones

If the battery change icon (
you must replace all the batteries. Once the batteries have been removed from the unit, the time must
be set again.
Power Supply Unit
You can also operate this device with an AC Power Adapter (not included). You MUST remove the batteries
before powering this unit with an AC Adapter. Only use an AC Power Adapter with specifications according
to section "Power supply unit".
1. Insert the round power plug from the AC Power Adapter into the AC Adapter Jack on the right hand
side of the blood pressure monitor. Plug the AC Power Adapter into a standard electrical outlet.
2. When finished using the device, unplug the AC Power Adapter from the electrical outlet and disconnect
it from the blood pressure monitor. When you unplug the AC Power Adapter, date and time settings
will be lost but saved measurements will remain.
Set the date and time as described below. Any saved measurements will be retained.
Setting the hour format, date, time and language:
If date and time are not set, stored measurements will not have a valid timestamp associated with them.
NOTE: Press and hold the + or - Buttons to advance values rapidly.
1. Press and hold the M Button for five seconds. The year will flash in the LCD Display. Use the +/-
Buttons to adjust the year and press the M Button to confirm.
2. The month flashes on the LCD Display. Set the month with the +/- Buttons and press the M Button
to confirm.
3. The day flashes on the LCD Display. Set the day with the +/- Buttons and press the M Button to confirm.
4. The hour flashes on the LCD Display. Set the hour with the +/- Buttons and press the M Button to
confirm.
5. The minutes flash on the LCD Display. Set the minutes with the +/- Buttons and press the M Button
to confirm.
6. The Language Selector will flash on the LCD Display. Select "L1" for English, L2 for Spanish, or L0 for
no audio output and press the M Button to confirm.
7. The Volume Selector will flash on the LCD Display. Select Vo1 for low, Vo2 for medium, Vo3 for loud,
or Vo0 for off. Press the M Button to confirm and exit.

6. Measuring Blood Pressure

The blood pressure monitor needs to be at room temperature when measuring.
Measurements can be performed on either arm.
Positioning the Cuff:
1. Place the cuff round your bare left upper arm 1 in to 1.5 in (2-3 cm) above the
bend of the elbow and above the artery, with the Air Tube in line with the center
of the palm. Ensure blood circulation is not restricted by tight clothing or other
objects.
2. Fasten the cuff, making sure it is not too tight around your arm. You should be
able to fit two fingers under the cuff after it is in place.
) is continuously illuminated, measurement is no longer possible and
9