Motion CM-34 Manual De Instrucciones página 16

De-activate
7
direct control
16
When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
Shortly press the program button on the smart switch. The blind will start stepping and
7.1
the LED on the smart switch will start blinking, indicating that program mode has been
activated.
Hold the program button until the blind stops stepping (approximately 5 seconds) to
7.2
de-activate or re-activate direct control.