Motion CM-34 Manual De Instrucciones página 19

Reset the blind
10
It is possible to only delete end limits or to do a factory reset.Factory reset will delete
the end limits and remove the connection to any paired remote.
Shortly press the program button on the smart switch. The blind will start stepping and the LED on the
10.1
smart switch will start blinking, indicating that program mode has been activated.(The blind remains
stepping until the program mode is de-activated.)
Delete end limits: To delete the end limits of the blind hold the program button until the blind stops
stepping for the first time, keep holding the button until the blind stops stepping for the second time.
(approximately 10 seconds)
Factory reset: To reset the blind to factory defaults hold the button for at least 20 seconds.The blind
will stop stepping twice. After the second stop the blind will give one extra step to confirm factory
reset.
19