Installing/Replacing The Lamp; Danger To Life - EuroLite MF-5 Manual Del Usuario

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For installation, a 230 V/300 W G-6.35 lamp is required.
The lamp in use can reach temperatures of up to 870° C.
Procedure:
Step 1: Unscrew the the 6 fixation-screws on top of the housing.
Step 2: Remove the upper housing-cover.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Put the new 230 V/300 W G-6.35 lamp into the lamp-socket.
Step 5: Replace the housing-cover and tighten the screws.
Rigging
Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened housing!
DANGER TO LIFE!
11