AGV BLADE Instrucciones De Uso página 12

1
1 1
1
1
1
12
Exe_Blade8_DEF 12
2
2
2
2
2
3.2) Crown pad Removal/Installation
To remove the crown pad, release the 2
press-studs at the front and the 2 at the
back of the helmet (1). Detach the part
of the crown pad equipped with Velcro
(2) from the two sides and remove from
the helmet, as shown in the figure.
To refit the crown pad, insert it inside
the helmet and clip the 2 press-studs at
the back and the 2 at the front (1) into
place. Press the part equipped with Vel-
cro (2) against the two sides as shown
in the figure.
3.3) Removal / Installation of the
padded neck roll (standard fitting on
Blade LX)
To remove the padded neck roll, fully
open the zip that joins it to the helmet and
remove it as shown in the figure below.
To refit the padded neck roll, insert the
pin of the zip into its housing (1) and fully
close the zip (2) as shown in the figure.
NB For the Blade, the padded neck
roll is available as an accessory only.
To fit it, proceed as indicated in the
figure above after removing the fabric
neck roll supplied, following the in-
structions at point 3.4.
3.4) Removal / Installation of the
fabric neck roll (standard fitting on
Blade)
To remove the fabric neck roll, fully open
the zip (1), free it from the Velcro (2) and
remove it as shown in the figure.
21-03-2007 11:09:50