AGV BLADE Instrucciones De Uso página 17

1
1
NB In the shell only configuration (configuration 1), shell + short peak (configuration 2), shell + visor (configuration 4), the
side screws with bayonet connection unscrew in an ANTICLOCKWISE direction and screw in a CLOCKWISE direction.
In the shell + long peak configuration(configuration 3), shell + visor + long peak (configuration 5), the side screws with
bayonet connection unscrew in a CLOCKWISE direction and screw in an ANTICLOCKWISE direction.
Exe_Blade8_DEF 17
2
3
2
To fit the long peak together with the
visor (configuration 5), follow the in-
structions in the figure below. Leaving
the visor in the fully lowered position
and starting from one of the two sides
of the helmet, turn the side screw
90° anticlockwise (1) and remove it.
Repeat operation (1) on the other side.
Starting from one of the two sides of
the helmet, insert the long peak so
that the side inserts coincide with the
movement base housings (2). Holding
the peak in place, insert the side screw
so that the two pins fit into the hooks on
the movement base and turn the side
screw 90° anticlockwise (3) to tighten
it. Repeat operations (2) and (3) on the
other side.
NB The visor + peak configuration is
possible with the long peak only.
To remove the peak with the visor, follow
the instructions in the figure below: with
the visor in the fully lowered position,
starting from one of the two sides of the
helmet, turn the side screw 90° clockwise
(1) and remove it. Repeat operations on
the other side. Remove the peak (2).
21-03-2007 11:10:00
17