Setting The Laser; Emptying/Changing The Chip Bag - HOLZMANN MASCHINEN KAP305JL Manual De Usuario

- Loosen the flange screw (S3) with the wrench (4). Note: Left-hand thread !
- Remove the flange screw (S3) and the flange disc (3).
- Remove the saw blade from the spindle.
- Clean the reducing ring (6) and insert it into a new saw blade.
- Place the new saw blade on the spindle. Ensure the correct direction of rotation!
- Place the flange screw (S3) and the flange disc (3) and tighten them.
- Move the movable protective hood to its initial position
- Fix the plate (1) again
- Check that the saw blade guard cover works properly and moves up and down when the saw
arm is moved. (Saw arm position up Saw blade guard covers the saw)
Pay attention to correct direction of rotation and dimension of the saw blade.
Limits for dimension: Max. Diameter of 305mm and max. thickness of 3mm, as
well as mounting diameter of 30mm.
- Before continuing with your work, make sure that all safety devices are in good operating
condition. (Saw blade protection check)
- Important! Always when you change the saw blade, check that it rotates freely in the table
insert in both cases. Vertical and 45° angle settings.
- Important! The work for changing and aligning the saw blade must be carried out correctly.

17.2.4 Setting the Laser

17.2.5 Emptying/changing the chip bag

HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
C A U T I O N
If the laser (17) does not show the correct cutting
line any more, you can adjust the laser. Loosen the
Phillips screws (S) and adjust the laser by moving it
sideways until the laser beam hits the teeth of the
saw blade. Tighten both screws (S) again.
The saw is equipped with a sawdust and chip
collection bag (1).
Attention! The sawdust bag (1) may only be used for
cutting wood and wood-like materials!
Press the metal ring (3) on the sawdust bag (1)
together and fasten it to the dust outlet (2). The chip
bag can be emptied by means of a zipper (4).
www.holzmann-maschinen.at 45
KAP305JL