Battery Substitution; Disposal - I-Tech MIO-PERISTIM Manual De Instrucciones

Use a dry cloth to clean the battery charger.
Do not open the battery charger: it does not contain repairable parts.

Battery substitution

Remove the clip belt, then open the battery compartement on the back side
of the device. Disconnect the cable and take away the battery. Connect the
cable of the new battery, close the battery compartment and insert the belt
clip.
WARNING. The life of the battery depends on the number of
charge/recharge cycles.
We suggest the following precautions for a battery longer duration:
• Recharge the battery once in a month even if the device is not used;
Discharge the battery as much as possible before the recharging;
•
Use only the original battery charger or in any case the battery
•
charger supplied by the fabricant/distributor. Not open or modify
the battery charger.

Disposal

MIO-PERISTIM was designed and engineered to have minimal negative
environmental impact, in consideration of its performance and safety
requirements, following the disposition given by the European Directive
2012/19/EU, regarding the waste of electrical and electronic equipment.
Rigorous standards were followed in order to minimize the amount of waste,
use of toxic materials, noise, non-required radiation and energy consumption.
A deep research on the optimization of machine performances guarantees a
significant consumption's reduction, in accordance to the saving energy
principles.
IACER Srl
WARNING. Remove the battery in case
of prolonged
months).
Batteries have to be handled by adult persons:
keep them out of children's reach.
71
inactivity (over two
MNPG152-07