Led Display; Operation - INVENTOR CLCO290-09 Manual De Usuario

|Operation

Power
indicator light
Timer mode
indicator
light (set only by
remote controller)
MODE button
Choose the desired operating mode.
By pressing the MODE button each
time an operation is selected in the
following order: COOL – FAN – DRY.
Indication led will illuminate under the
desired MODE setting.
NOTE: On above modes, the unit operates
the auto fan speed automatically. You can
set fan speed only by the remote controller
on COOL and FAN modes.
Up (+) and Down (-) buttons Are used
to set the temperature in increments of
1ºC or 2ºF ranging from 17ºC (62ºF) to
30ºC (86ºF).
NOTE: The remote control may display
the temperature in both Fahrenheit or
Celsius. To change press and hold the
up/ down buttons for 3 sec.
Power button
Power switch on/off.

LED display

Shows the set temperature while on cool mode.
While on DRY and FAN modes,
it shows the
room temperature. Shows
Error codes:
E1-Room temperature sensor error.
E2-Evaporator temperature
sensor error.
E4-Display panel communication
error.
EC-Refrigerant leakage detection malfunction
(on some models).
Shows protection code:
P1-Bottom tray is full--Connect the drain hose
and drain the collected water away.If
protection repeats,call for service.
Note: When one of the above malfunctions
occurs, turn off the unit, and check for any
obstructions. Restart the unit, if the
malfunction is still present, turn off the unit and
unplug the power cord. Contact the
manufacturer or its service agents or a similar
qualified person for service.