INVENTOR CLCO290-09 Manual De Usuario página 18

|Operation
Other features
SLEEP/ECO operation
This feature can be activated with the use of the
remote control only. When SLEEP mode is
activated the set temperature will increase by
1C/2F within 30 minutes. The set temperature
will again increase by another 1C/2F during the
next half hour. This new temperature will be
maintained for the next 7 hours, after the
duration of the above time frame the unit will
return to the initial set temperature and ending
the SLEEP mode. This feature is not available
under DRY or FAN mode.
AUTO-RESTART
In the event of power loss the unit will
regain operation, once power resumes, with
the last settings.
AIR FLOW DIRECTION ADJUSTMENT
Adjust the air flow direction manually:
-The louver can be set to the desired
position manually.
-Do not place any heavy objects or other loads
on the louver, doing so will cause damage to
the unit.
-Keep the louver fully opened during operation.
WAIT 3 MINUTES BEFORE
RESUMING OPERATION
Once the unit has stopped its operation, it can
not be restarted within the first 3 minutes, for
the protection of the device. Operation will
automatically restart after 3 minutes.
16
Water drainage
When under dehumidifying mode, remove the
drain plug for the back of the unit and install the
drain connector (5/8 universal female mender)
with a 3/4 hose (may be purchased locally). For
models without the drain connector, please
attach the drain hose to the outlet, while placing
the other side of the hose directly over the
drainage port of your basement floor.
Remove the
drain plug
NOTE: Be certain the hose is secure without
any leaking. Direct the hose toward the drain,
in such a manner that there are no breaks or
bents securing smooth water flow. When the
continuous drain hose is not of use, ensure
the drain plug is installed firmly to prevent
possible leakage.
When the water level of the bottom tray
reaches a predetermined level, the unit beeps
8 times; the digital display area shows "PI". At
this time the air conditioning/dehumidification
process will immediately stop. However, the
fan motor will continue to operate (this is
normal). Carefully move the unit to a drain
location, remove the bottom drain plug and let
the water drain. Re-install the bottom drain
plug and restart the machine until the "PI"
symbol disappears. If the error persists,
please call for service.
NOTE: Be sure to reinstall the bottom drain
plug firmly to revent leakage before using
the unit.
Continuous
drain hose
Bottom drain
plug
EN