SafetyInstructions - Cata AG6-A600 GBK Instrucciones Para La Instalación, El Uso, El Mantenimiento

SAFETY INSTRUCTIONS
T
his manual explains the proper installation and use of your cooker hood,
please read it carefully before using even if you are familiar with the product.
The manual should be kept in a safe place for future reference.
Never to do:
D
o not try to use the cooker hood
●
without the grease filters or if the filters
are excessively greasy!
D
o not install above a cooker with a
●
high level grill.
D
o not leave frying pans unattended
●
during use because overheated fats or
oils might catch fire.
N
ever leave naked flames under the
●
cooker hood.
I
f the cooker hood is damaged, do not
●
attempt to use.
D
o not flambé under the cooker hood.
●
C
AUTION: Accessible parts may
●
become hot when used with cooking
appliances.
T
he minimum distance between the
●
supporting surface for the cooking
vessels on the hob and the lowest part
of the cooker hood. (When the cooker
hood is located above a gas appliance,
this distance shall be at least 65 cm)
T
he air must not be discharged into a
●
flue that is used for exhausting fumes
from appliances burning gas or other
fuels.
Always to do:
I
mportant! Always switch off the
●
electricity supply at the mains during
installation and maintenance such as
light bulb replacement.
T
he cooker hood must be installed in
●
accordance with the installation
instructions and all measurements
followed.
A
ll installation work must be carried
●
out by a competent person or qualified
electrician.
P
lease dispose of the packing material
●
carefully. Children are vulnerable to it.
P
ay attention to the sharp edges
●
inside the cooker hood especially
during installation and cleaning.
M
ake sure the ducting has no bends
●
sharper than 90 degrees as this will
reduce the efficiency of the cooker
hood.
W
arning: Failure to install the screws
●
or fixing device in accordance with
these instructions may result in
electrical hazards.
W
arning: Before obtaining access to
●
terminals, all supply circuits must be
disconnected.
16