Use - Imetec TITANOX K113 Instrucciones De Uso

Ocultar thumbs Ver también para TITANOX K113:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
EN
synthetic, acrylic, nylon, polyester: low temperatures;
wool, silk: medium temperatures;
cotton, linen: high temperatures;
do not iron.
FILLING THE RESERVOIR
Verify that the plug (12) is disconnected from the socket.
Set the steam selector (5) to 0 [Fig. B].
Open the latch (6).
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly pour the water into the reservoir (10) using the special cup (13) [Fig. C].
Do not exceed the maximum fill-up level (8) indicated on the reservoir (10).
Close the hatch (6).
SELECTING THE TEMPERATURE
Set the iron upright.
Insert the plug (12) in the socket.
Set the temperature according to the type of fabric in line with the international symbols
shown on the labels; using the adjustment knob (2), [Fig. D].
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to go off before starting to iron.
Consult the table below for the correct temperatures.
Garment
label
IRONING WITHOUT STEAM (DRy)
Follow the instructions in the "steam ironing" section, leaving the steam selector (5) set to 0.
IRONING WITH STEAM
Select the amount of steam via the steam selector (5).
Move the steam selector (5) to any position between minimum and maximum according to
the desired amount.
Continuous steam will only be dispensed when the iron is in a horizontal position.
This stops when the iron is set upright or the steam selector (5) is set to 0.
Steam can only be used at the highest temperatures, as indicated by the symbol on the
14

USE

Fabric
type
synthetics
e.g. viscose, polyester
silk, wool
cotton, linen
Temperature
selector
• •
• • •

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

70909

Tabla de contenido