Troubleshooting - Imetec TITANOX K113 Instrucciones De Uso

EN
Avoid scratching the plate with steel wool or metal objects.
The plastic parts can be cleaned with a damp cloth and then wiped with a dry cloth.
This chapter describes the most common problems that can arise using the appliance. If
the problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem
The plate (9)
remains cold or
does not heat up.
The plate
temperature LED
(1) goes on and off.
Only a little steam
or none at all is
dispensed.
The impurities that
come out from the
steam holes
stain the
garments.
16

TROUBLESHOOTING

Possible cause
There is no power supply.
Normal procedure.
The steam selector (5) is
set to 0.
There is not enough water
in the reservoir (10).
Chemical additives,
scented liquids or
descaling agents are being
used.
Pure distilled water or
softened water is being
used.
Starch is being used.
Solution
Verify whether the plug (12) is inserted
correctly or try inserting it in another
socket.
Verify whether the temperature
adjustment knob (2) is set to the
minimum temperature (Fig. D).
The switching ON and OFF of the
LED indicates the heating phase of
the iron. LED (1) goes off once the set
temperature is reached.
Set the steam selector (5) to the
desired field (Fig. B).
Fill the reservoir (10).
These substances damage the
product: do not use additives in the
water in the reservoir.
Mix tap water (50%) with distilled and/
or demineralised (50%) water.
Always spray the starch on the reverse
side of the fabric.