Steren ANT-UHF 16 Manual Del Usuario página 3

HOW TO ASSEMBLE YOUR NEW ANTENNA
We suggest you obtain help from a second person in order to
assemble and install your new antenna.
1. Place the impedance adaptor in the central mast. Make sure to place
the screw in the hole showed in fig. 1. On the other side, place the
separator on the screw and use the butterfly nut in order to tighten the
impedance adaptor.
2. In one end of the central mast, insert the "A" piece and on the other
end the "B" piece. Place the holding screw in the hole and tighten it
using the butterfly nut.
3. Place pieces "C" and "D" on either side of the antenna holding piece
and tighten them with the butterfly nuts until they are firmly in place.
4. Insert the cap in the TV's coaxial cable and connect this cable to the
"F" connector on the impedance adaptor. Afterwards, place the cap so
that it covers the antennas connector.
5. Set the antenna firmly on the mast by tightening the butterfly nuts.
(See fig. 4)
6. Direct the antenna to a clear area and towards the transmission
tower.
This package does not include a mast.
ENGLISH-03