Water Technologies & Solutions
Water Technologies & Solutions
Warnings
Sievers M500 and M500e
Sievers M500 and M500e
Online TOC Analyzers
Online TOC Analyzers
Warnings
This symbol on the instrument indicates that the user
This symbol on the instrument indicates that the user
should refer to the manual for operating instructions.
should refer to the manual for operating instructions.
The iOS System and vial ports contain sharp needles
The iOS System and vial ports contain sharp needles
designed to pierce the septa of sample vials. Do
designed to pierce the septa of sample vials. Do not
put fi ngers or inappropriate materials into the iOS
put fi ngers or inappropriate materials into the iOS
System or vial port.
System or vial port.
Water in the iOS system may be hot. Before inserting
Water in the iOS system may be hot. Before inserting
a vial into the iOS system after operating in Online
a vial into the iOS system after operating in Online
mode, slide the door open and wait 30 seconds to
mode, slide the door open and wait 30 seconds to
allow sample to completely drain. Inserting a vial
allow sample to completely drain. Inserting a vial
before draining can result in hot water spray projecting
before draining can result in hot water spray projecting
upward out of the iOS system.
upward out of the iOS system.
This symbol indicates the protective earth terminal
This symbol indicates the protective earth terminal
(ground) for the Analyzer.
(ground) for the Analyzer.
This symbol indicates the European Union Directive
This symbol indicates the European Union Directive
2012/19/EU for waste electrical and electronic
2012/19/EU for waste electrical and electronic
equipment (WEEE) requires disposing the Analyzer
equipment (WEEE) requires disposing the Analyzer
separately from standard waste.
separately from standard waste.
To avoid potentially dangerous shock, before
To avoid potentially dangerous shock,
Analyzer, stop any analysis and power off the operating system.
Analyzer, stop any analysis and power off the operating system.
Press the Power Off button in the Analyzer's fi rmware, then turn
Press the Power Off button in the Analyzer's fi rmware, then turn
off the power switch and disconnect from the power supply. Any
off the power switch and disconnect from the power supply. Any
operation requiring access to the inside of the Analyzer without
operation requiring access to the inside of the Analyzer without
turning off power, including installation of maintenance items,
turning off power, including installation of maintenance items,
could result in injury.
could result in injury.
To protect against accidental exposure to ultra-violet radiation,
To protect against accidental exposure to ultra-violet radiation,
do not operate the UV lamp outside of its protective housing. The
do not operate the UV lamp outside of its protective housing. The
UV lamp housing may be hot. Use extreme caution whenever
UV lamp housing may be hot. Use extreme caution whenever
touching the UV lamp housing.
touching the UV lamp housing.
Risk Group 3 Warning: UV emitted from this product. Avoid eye
Risk Group 3 Warning: UV emitted from this product. Avoid eye
and skin exposure to unshielded product.
and skin exposure to unshielded product.
The glass window in the UV reactor indicates proper lamp
The glass window in the UV reactor indicates proper lamp
operation and should not be viewed too closely (closer than 6
operation and should not be viewed too closely (closer than 6
inches) or for extended periods (greater than 1 minute). Protective
inches) or for extended periods (greater than 1 minute). Protective
eyewear is recommended.
eyewear is recommended.
If this instrument is used in a manner not specifi ed by SUEZ, the
If this instrument is used in a manner not specifi ed by SUEZ, the
protection provided by the instrument may be impaired.
protection provided by the instrument may be impaired.
To avoid injury and to ensure accurate analysis results, ensure that
To avoid injury and to ensure accurate analysis results, ensure that
the Analyzer door is closed and latched during normal operation.
the Analyzer door is closed and latched during normal operation.
© 2020 SUEZ. All Rights Reserved.
English
before opening the
opening the
This symbol on the instrument indicates that the product does
contain restricted substances included in China RoHS II.
Please refer to the following table.
not
Please Note: This product contains a UV Lamp (with Hg) which meets the exemption
defi ned in Annex III 4(a) of RoHS Directive 2011/65/EC.
To assure safe operation of the instrument, the AC Mains Earth
To assure safe operation of the instrument, the AC Mains Earth
Ground must be securely connected to the enclosure.
Ground must be securely connected to the enclosure.
Always stop analysis before turning off the Analyzer.
Always stop analysis before turning off the Analyzer.
This is a Safety Class I product. It must be must be attached to
This is a Safety Class I product. It must be must be attached to
a grounded power source. To avoid damage to the Analyzer and
a grounded power source. To avoid damage to the Analyzer and
the chance of injury, make sure the Analyzer is connected to a
the chance of injury, make sure the Analyzer is connected to a
power line of the proper voltage.
power line of the proper voltage.
This is a Class A product. In a domestic environment, this
This is a Class A product. In a domestic environment, this
product may cause electromagnetic interference. Take
product may cause electromagnetic interference. Take
adequate measures to correct the interference.
adequate measures to correct the interference.
Consult the MSDS that accompanies each standards set to
Consult the MSDS that accompanies each standards set to
identify proper disposal techniques.
identify proper disposal techniques.
To avoid potentially dangerous shock, do not touch anything
To avoid potentially dangerous shock, do not touch anything
inside the Analyzer while observing the sample pump during a
inside the Analyzer while observing the sample pump during a
visual inspection.
visual inspection.
Take extreme care to avoid getting electrical components wet
Take extreme care to avoid getting electrical components wet
when performing this procedure.
when performing this procedure.
The UV lamp contains mercury and may be considered
The UV lamp contains mercury and may be considered
hazardous material in your local area. Dispose of these items in
hazardous material in your local area. Dispose of these items in
accordance with federal, state, or local government regulations.
accordance with federal, state, or local government regulations.
19
Sievers
®
is a trademark of SUEZ and may be registered in one or more countries.
DQS 78000-01 MUL Rev. A