Impres Battery Initialization; Automatic Impres Calibration And Recondition - Motorola Solutions IMPRES PMPN4527 Manual Del Usuario

MN007272A01-AA
Chapter 2 : IMPRES Batteries and Chargers
Status
Standby
End of Service Life
Recalibration
2.3

IMPRES Battery Initialization

For a full IMPRES functionality, a new IMPRES battery must be initialized by the charger.
The charger automatically detects the new IMPRES battery, and automatically starts initialization.
Initialization is the first calibration and reconditioning of an IMPRES battery.
Phases of Battery Initialization
The first phase is a battery discharge, indicated by a steady amber LED. The second phase is a full
charge, indicated by a steady green LED. Refer to
NOTE: This process may take up to 12 hours or more to complete, depending on the state of
charge and capacity of the battery. Interruption of either phase delays initialization until the next
charging opportunity.
2.4

Automatic IMPRES Calibration and Recondition

The IMPRES charger automatically assesses the condition of an IMPRES battery.
Based on the condition, the charger automatically calibrates and reconditions the battery. This process
starts with battery discharge, indicated by a steady amber LED status. Calibration and recondition
are complete only after a full charge, indicated by a steady green LED status. See
Charging Indicators on page
This process can take up to 12 hours or more to complete, depending on the charging status and
battery capacity. Interruption of either the discharge phase or the full charge phase delays calibration
until the next charging opportunity.
10
LED Status
9.
Flashing amber
Alternating red and
green
Alternating amber and
green
IMPRES Battery Charging Indicators on page
Comments
• Battery is waiting
to rapid charge.
• Battery may be too
hot, too cold, or
low voltage.
• Charger may be
too hot.
Battery remains usa-
ble but may be near-
ing the end of its rated
service life.
Battery requires calli-
bration or battery is
due for callibration.
9.
IMPRES Battery