Charging A Stand-Alone Battery - Motorola Solutions PMLN7093 Guia Del Usuario

CHARGING A STAND-ALONE BATTERY

Note: Align the battery to the charger pocket ensuring that the contacts are properly
fitted.
TROUBLESHOOTING
When troubleshooting, always observe the color of the LED:
LED Charger State
Indication
Charger successfully powered up
and is ready for use.
Single Flash
Green
No Battery in Pocket
Off
•
•
Waiting to Rapid Charge
•
Amber Slow
Flash
•
•
•
Figure 2: Charging Stand-Alone Battery
Table 4: Charger LED Indicator
The Charger identified the
Battery as invalid or damaged
The Charger may have
detected an open or shorted
Battery contact
Battery Under-Voltage
Recovery
Battery too Cold, Temperature
< approximately 5°C (or value
programmed in battery)
Battery too Hot, Temperature
≥ approximately 45°C (or
value programmed in battery)
Thermistor short to Battery (+)
Comment
The charger is ready for use.
If a battery is in the pocket, ensure
that the power cord is plugged into
the proper main outlet.
If the indication continues, remove
the battery. Inspect the charger and
battery contacts to ensure they are
clean. Reinsert the battery.
Upon completion of Under-Voltage
Recovery, once a cold battery
warms up or once a hot battery
cools down, the charger
automatically transition to
Charging.
If Waiting to Rapid Charge
continues (e.g., more than
30 minutes), then remove the
battery. Inspect the charger and
battery contacts to ensure they are
clean. Reinsert the battery.
4