Bremont AC35 Manual Del Usuario página 4

ChANGiNG ThE sTRAP
REmOvINg A STRAp
Use the end of your watch tool
to carefully lever the spring bar
out of the lug.
FITTINg A STRAp
Place one end of the spring bar
into the hole in the lug and use
the end of the watch tool to
lever the other end into position.
If you require a strap change it is strongly advised that you visit your
Authorised Dealer to avoid damage to the case.
BREMONT AC35
Your Bremont watch shows you the time in hours, minutes and seconds, and
the date. The BWC/01-10 mechanical movement with automatic winding
has a free-swinging rotor that keeps the mainspring wound via the motion
of your wrist. The movement in your AC35 has 25 jewels, runs at 28,800 A/h
and has a 50+ hour power reserve once fully wound. The watch is water
resistant to 100m (10ATM) and the dial is protected by a multi-layer anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
wiNdiNG ThE wATCh
Your watch has a screw-in crown. The purpose of the screw-in crown is
to protect the watch from penetrating water and to avoid unintentional
adjustment of the time or date. To unscrew the crown, rotate the crown
anti-clockwise where it will automatically assume position I. This position
is also the winding position for the watch, and you can manually wind
the watch by hand by rotating the crown clockwise. The movement will
automatically start with just a few revolutions of the rotor, however it is
better to wind the movement fully with 30-40 revolutions of the crown.