Setting The Date; Setting The Time - Bremont MBI Manual Del Usuario

seTTIng The daTe

You can adjust the date by pulling out the crown to position II. You will
now be able to change the date by rotating the crown clockwise.
Do not change the date between 20:00 and 03:00
In this position you can also adjust the day by rotating the crown anti-
clockwise.

seTTIng The TIMe

Pull the crown out to position III, this will stop the movement, you can
now position the minute hand exactly. To start the second hand, push the
crown back to position I. When setting the time, it is worth noting that
the date change always takes place at mid-night (00:00). If this change has
already taken place at 12:00 noon, you must move the hands forward by 12
hours. Ensure that the crown is pushed back in after setting the watch.
usIng The roTo-ClICk® Bezel
Your MBI/MBII is fitted with an internally rotating Roto-Click® bezel with
minute calibration. The bezel can be moved, both in a clockwise and anti-
clockwise direction using the bezel crown positioned at 4 o' c lock. To use the
timing function, rotate the bezel until the red triangle marker is in line with
the minute hand, the elapsed time can now be measured and read using the
minute hand against the minute and hour markers on the dial ring.
ChronoMeTer TesTIng
Your Bremont watch is chronometer tested and accompanied by a
performance certificate issued by the 'Controle Officiel Suisse des
Chronometeres' (COSC) to show that the mechanical movement has
passed all of the rigorous precision tests - a necessity of the chronometer
designation.
Remember to complete and return the CosC registration card to
Bremont to register your watch and receive your certificate.
The chronometer certification, which takes 15 days to complete over
several different temperature ranges and watch positions, means that
the average daily variation rate will be between -4 and +6 seconds. With
86,400 seconds in a single day, this gives Bremont' s watches an accuracy of
99.998%.