Setting The Date - Bremont AC-R-II Manual Del Usuario

BRemonT AC-R-II
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. With the chronograph you can measure up to 12 hours using
an individual timer and countdown from 15 minutes using the Regatta
function. The mechanical movement with automatic winding has a free-
swinging rotor that keeps the mainspring wound via the motion of your
wrist. The movement in your AC-R-II has 25 jewels, runs at 28,800 A/h
and has a 42-hour power reserve once fully wound. The watch is water
resistant to 100m (10ATM) and the dial is protected by a multi-layered anti-
reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
wIndIng The wATCh
Your AC-R-II can be wound from crown position I by rotating the crown
in a clockwise motion. The movement will automatically start with just a
few revolutions of the rotor; however it is better to wind the movement
fully with 30-40 revolutions of the crown. By doing this you will achieve
maximum accuracy and have a power reserve of 42-hours, even when the
watch is not on your wrist.

seTTIng The dATe

You can adjust the date by pulling out the crown to position II. You will
now be able to change the date by rotating the crown clockwise.
Important notice: Do not change the date between 20:00 and 03:00.
seTTIng The TIme
Pull the crown out to position III, this will stop the movement, you can
now position the minute hand exactly. To start the second hand, push the
crown back to position I. When setting the time, it is worth noting that
the date change always takes place at mid-night (00:00). If this change has
already taken place at 12:00 noon, you must move the hands forward by
12 hours.
usIng The 15-mInuTe RegATTA CounTdown FunCTIon
Positioned at 12H is the countdown/timer feature of your AC-R-II.
At reset the Regatta minute timer will be set to zero. To start the
countdown timer press Push-Button A. The hand will move a full
segment of the countdown dial every minute, after five minutes the
hand will be aligned